WINDING

UNW CR2/S
Machine designed for unwinding and rewinding material wound on a core or material placed in the cradle. Speed is controlled by angle of the Dancer. The machine is equipped with puller for possibility of winding heavier materials. The machine can be equipped with side controll.

Type of the machine

ICZ 1300 UNW CR2/S

ICZ 1600 UNW CR2/S

ICZ 2300 UNW CR2/S

Working width of the machine

1 300 mm

1 600 mm

2 300 mm

Units in the machine

Dancer

The machine is equipped with a sensor for monitoring sag of material. Based on the information from this sensor is controlled the drive shaft. Winding with sag allows for material take-up from the outgoing production line with reduced stretching.

Puller

The machine is equipped with a puller to assist the drive during winding. It also serves to create tension of the material between the subsequent machine and the unwinder.

Side controll

The machine is equipped with a device for checking the alignment of winding. If the material is unwound off-center, the machine will slightly adjust its position to realign it.

Where you can find us?

12 + 3 =

Address

INTERNATIONAL CZ, spol. s r.o.
U Tescomy 238, 763 11 Zlín – Lužkovice
Comp. ID: 25532481, VAT ID: CZ25532481
GPS: 49°13’27.056″N, 17°43’57.025″E

Phone

+420 577 210 217

Email

international@mb-international.cz